The Yocan Magneto Vaporizer is beautiful and comfortable to use. It's easier than ever to find the perfect level of intensity you want. This article will show you how to assemble your device.

Step 1: Acquiring the Contents

The first thing you need to assemble your Yocan Magneto vaporizer is to acquire all the parts listed in this article. This includes the following: Yocan Magneto herbal vaporizer, 13mm magnet for cartridge, 14mm magnet for the cartridge, black mouthpiece cap, e-nail cover with two magnets, two magnets (10x smaller than 13mm but ideally same shape), high-quality silicone sealant or superglue.

Step 2: Inserting the Battery

There's a small, flat edge that needs to be aligned with the top grid in order for the tray to fit into the vaporizer. To do this, flip the tray over and screw in one of the sides. Do not yet secure any screws. Flip it back up to see if it bears weight where it needs to, then tighten the side you initially threaded in until it does so.

Step 3: Inserting the Coil Cover

One the vape coil cover has been inserted into the coil, set that coil into the lower end of the glass. You may need to use a hard object or other parts of your hand to hold it in place. That makes up step 3!

Step 4: Packing The Mouthpiece Assembly

Check to make sure that the mouthpiece tab has been inserted into opening 1, slots close together.

Step 5: Attaching the Drip Tip

The Drip Tip will be fitted into the head of the Magneto vaporizer. A user-friendly magnetic assembly will allow you to install your drip tip with ease. Screw screwed, done!